Engineering College


Design a driver circuit that should drive a a seven segment to display octal numbers
[0 up to 7]. Your work should include the following steps
1) An appropriate title
2) The truth Table
3) Simplified expressions for the appropriate circuit
4) Logical circuit for the driver.​

Design A Driver Circuit That Should Drive A A Seven Segment To Display Octal Numbers[0 Up To 7]. Your

Answers

Answer 1

Answer:

point hehe sorry sorry

Explanation:

I don't know

Related Questions

Which of the following is a slow rise of plastic deformation under the action of shear stresses when it is below the yield strength of the material.

a.Brittle Structure

b.Ductile fracture

c.Creep

d.Fatigue

Answers

Creep can be described as a process of the slow rise of plastic deformation under the action of shear stresses when it is below the yield strength of the material. Hence, Option C is correct.

What do you mean by permanent deformation?

Permanent deformation can be defined as irreversible, the deformation remains even after the elimination of the carried out forces, at the same time as the transient deformation is recoverable because it disappears after the elimination of carried out forces.

therefore, the correct statement is  Option C.

Learn more about permanent deformation

https://brainly.com/question/10667384

#SPJ1

Tech A says that if a CV boot is torn, it can typically be replaced without replacing the entire joint or shaft. Tech B says that worn CV joints can make a clicking noise when driving while making a tight turn. Who is correct

Answers

Both Technician A and Technician B are correct based on the information provided.

When to replace a CV boot?

The CV boot on an automobile vehicle should be replaced when it is torn but shouldn't have been torn for too long. Thus, you should just replace the boot when the CV joint is not yet completely damaged or full of dirt.

Similarly, worn CV joints in an automobile vehicle can make a clicking noise when driving while making a tight turn on a road.

Read more on CV joints here: https://brainly.com/question/12239770

#SPJ12

he minimum number of branch circuits is determined from ____ load and the size (or rating) of the circuits used.

Answers

The minimum number of branch circuits is determined from the total computed load and the size (or rating) of the circuits used.

What is circuit?

It should be noted that circuit means a complete circular path that electricity flows through.

In this case, the minimum number of branch circuits is determined from the total computed load and the size (or rating) of the circuits used.

Learn more about circuit on:

brainly.com/question/2969220

#SPJ12

When adding two 8 bit binary numbers, which of the following statements is true?

Answers

Answer:

The result might require 9 bits to store

3 To improve the acoustics in auditorium, a sound reflector with mass
of 200 kg is suspended by a chain from the ceiling. What is its
weight? What force (magnitude and direction) does the chain exert
on it? What is the tension in the chain? Assume that the mass of the
chain itself is negligible.

Answers

To improve the acoustics in auditorium, a sound reflector with mass of 200 kg is suspended by a chain from the ceiling thus thet force (magnitude and direction) does the chain exert on it =1960 N.

What is Newton's third regulation?

Ths  0.33 regulation states that for each movement (pressure) in nature there's an identical and contrary response. If item A exerts a pressure on item B, item B additionally exerts an identical and contrary pressure on item A. In different words, forces end result from interactions.

Weight of reflector = mg=200^ * 9.8=1960 NForce exerted with the aid of using chain =1960 NDirection = upwardsTension at the chain = weight of reflector=1960 NWeight of reflector =mg =100 * 9.8=980NMagniyof pressure reflector exerts on earth = 980 N(Due to movement response pair of forces, consistent with Newton's 0.33 regulation of motion.

Read more about the Newton's law:

https://brainly.com/question/25545050

#SPJ1

Other Questions
A cup of water is warmed from 29 C to 97 C. What is the difference between these two temperatures, in kelvins Write an equation in point-slope form of the line that passes through the given point and with the given slope m(-9,2); m=6 CWhy do governments often regulate business in a capitalist society?Oto prevent the overproduction of productsOto guarantee the development of big businessOto prevent environmental problems and disastersOto guarantee employment for every worker The actual mass of a sheet of copy paper is 4.5 g. What must be the actual mass of a 1 cm plece of copy paper?Show your calculations. 10. I still remember the joys which I experienced in my childhood. what type of sentence is this What did the Brown v. Board of Education decision do? Which statement best summarizes the central idea of this paragraph? Examination malpractice dilutes sanctity and integrity of certificate By using a following distance greater than three seconds and allowing for additional clear distance ahead before passing, a driver can:________ a. increase field of vision. b. compensate for poor depth perception. c. improve visual acuity. d. concentrate on tunnel vision A. Point SourceB. Non-Point SourceThis would beconsidered whattype of waterpollution? What is the solution to 3(3x + 9) = 18?O x = -5O x = 5 or x=1O x = -5 or x = 1no solution The graphs below have the same shape. What is the equation of the red graph? g(x) = A. g(x)=2^x+3-2 B. 2^x-3-2 C. 2^x-2-3 D. g(x)=^x+2-3 A person buys a used car with a down payment of $1,200 and makes monthly payments of $275 for 3 years.What is the total amount of the person pays for the car?PLEASE EXPLAINA.$2,025B.$9,900C.11,100D.13,500 Which details does the author include to support the central idea about how her mother felt about the dictator? Select three options.doubly revoltedobsessionin exileisolatedcautionary tales which expression is in simplest form? According to federal law, marijuana is legal for medical use in the United States true or false In pea plants, tallness (t) is dominant to shortness (t). what are the predicted percentages of the genotypes of the offspring if a homozygous short plant is crossed with a heterozygous tall plant? talumpati version courship ( old and new ways ) A nurse is caring for a newborn client who is diagnosed with myelomeningocele. Which nursing intervention would protect the newborn from injury How did being a democrat lead to problems for Andrew Johnson