Answer:
1. Place in a platic bag and use a magnet to attract the iron filings. [See explanation for an alternative step].
2. Disolve the remainer in water
3. Pass the liquid through a microporous filter to capture the undissolved sulfur
4. Evaporate the filtered water to retrieve iron chloride crystals
Explanation:
The Fe(II) chloride will dissolve in water. It is paramagnetic, and thus is weakly attracted to a magnet. The process above should not result in attracting the solid Fe(II) crystals. In fact, it is probably acceptable to dissolve the entire sample in water as the fisrt step. The dissolved Fe(II) chloride should also not be strongly attraced to a magnet, and htis step would allow easier separation of the iron filings.
Sulfur is not soluble in water, so it will collect as a dsolid in the microporous filter.
The Fe(II) has a high solubility, so it will wind up in the filtered soluition. Evaopate using heat or vacuum to retrieve the solid Fe(II) chloride crystals (they will be hydrated).
2) The coregion in the area of the Texas Panhandle. This coregion is level plates that ranges in elevation from 3000 to 4500. This is very fry dry and
the characteristics of this coon we would expect to see plenty of
A) wind ersoin
B) water ersoin
C) deposition of sediment
Answer:
the correct answer is B po sure po ako
Explanation:
Sure na sure po
Answer:
The map shows the various ecoregions of Texas. Which ecoregion is most vulnerable to wind erosion from hurricanes originating in the Gulf of Mexico? desert. A.
Explanation:
Which of the mechanical waves below has the most energy?
A. Red
B. Blue
C. Green
D. Gold
Answer:
A. Red
Explanation:
I dont understand. Please help me.
Answer:
B
Explanation:
it's has more water and will go active way faster
Answer:
Beaker b
Explanation:
This is because the temperature in beaker b is higher. Hot water has more kinetic energy. Therefore, it's particles move faster and collide more frequently with the particles of antacid tablet. So, the reaction occurs faster.
Hope this helps =)
9. A 2.00 L flask is filled with propane gas (CH) at a pressure of 1.00 atm and a
temperature of -15.0°C. What is the mass of the propane in the flask?
the correct amswer is 4.17g
A sample of no2 occupies 16,500 ml at stp. How many no2 molecules are in the sample?.
According to Avogadro's law equal volume of all gases at the same temperature and pressure contain equal number of molecules. At STP one mole of any gas behaving ideally occupies a volume of 22.414 L.
What is molar volume?The volume occupied by one mole of a substance at a given temperature and pressure is defined as the molar volume at that temperature and pressure. The value of molar volume of an ideal gas at STP is important in stoichiometric calculations.
At STP, the number of molecules of a gas is given as:
Number of molecules of a gas (N) = V₀ in L / 22.414 × 6.022 × 10²³
Here V₀ in L = 16500 = 16.5 L
N = 16.5 / 22.414 × 6.022 × 10²³
N = 4.433 × 10²³
Thus the number of molecules present is 4.432 × 10²³.
To know more about number of molecules, visit;
https://brainly.com/question/19109598
#SPJ2
how do you find the oxidation numbers for H3PO4
What is the pressure in a 8.00 L tank with 50.5 grams of chlorine gas at 365 K?
The pressure in a 8.00 L tank with 50.5 grams of chlorine gas at 365 K is 2.67atm.
How to calculate pressure?The pressure of a given mass of gas can be calculated using the following formula:
PV = nRT
Where;
P = pressureV = volumeT = temperaturen = no of molesR = gas law constantThe number of moles in 50.5g of Chlorine gas is as follows:
moles = 50.5/70.91
moles = 0.71mol
P × 8 = 0.71 × 0.0821 × 365
8P = 21..34
P = 21.34/8
P = 2.67atm
Therefore, the pressure in a 8.00 L tank with 50.5 grams of chlorine gas at 365 K is 2.67atm.
Learn more about pressure at: https://brainly.com/question/12971272
What is the molarity of NaCl when 5.0 moles of NaCl is dissolved in 2.0 L solution
Answer:
Molarity having mol/L that is moles of solute in per liters of solution.
mark as Brainliest please
Explanation:
substituted and expected value in the above education molarity equal to 0.5 mole by 2.0
1. Define the unit 'mole'
Answer:
Below
Explanation:
The mole, symbol mol, is the SI base unit of amount of substance. The quantity amount of substance is a measure of how many elementary entities of a given substance are in an object or sample
1. A sulfur atom has 16 protons, 18 neutrons, and 16
electrons. A sulfide ion has a 2– charge. Which of
the following is the correct number of particles that
make up a sulfide ion?
a. 18 protons, 18 neutrons, and 16 elections
b. 16 protons, 18 neutrons, and 18 electrons
c. 18 protons, 16 neutrons, and 16 electronis
d. 14 protons, 18 neutrons, and 16 electrons
e. 15 protons, 17 neutrons, and 17 electronis
Answer:
b. 16 protons, 18 neutrons, and 18 electrons
Explanation:
Things to be remembered
Negative charge on any ionic species indicates gained the electrons
Positive charge on any ionic species indicates lost the electrons
A sulfur atom has 16 protons, 18 neutrons, and 16 electrons, A sulfide ion has a 2– charge which indicates that sulphur has gained two electron from any other atom, ion or species!
Thanks for joining brainly community!
_______ are similar to molecular formulas but show how atoms are bonded together.
Answer
The structural formula are similar to molecular formulas but show how atoms are bonded together.
Explanation:
The structural formula for a compound gives the same information as its molecular formula (the types and numbers of atoms in the molecule) but also shows how the atoms are connected in the molecule.
What type of probes physically land on the surface of a planet or moon?
Answer:
Here are three types of probes that land on space physically. Interplantery, orbiters, and landers.
Explanation:
These are the ones that collect data and other stuff from space.
How many grams are in 2.3 moles of N?
Answer:
Therefore, 40.4 grams are contained in 2 moles of Neon.
Which additional product balances the reaction H2SO4 + 2NaOH → Na2SO4 + ________?
2H2O
2OH
H2O2
H3O
Answer:
2H2O
It's a double displacement reaction
what could you and your classmates do to reduce human impact on land
giving brainiest
Answer:
have controlled population!
Explanation:
PLEASE HELP ASAP
What does it mean that the collisions between gas particles are elastic?
Answer:
There is no net loss of energy from the collisions.
Explanation:
Gas particles are constantly colliding with each other and the walls of their container. These collisions are elastic; that is, there is no net loss of energy from the collisions. Gas particles are small and the total volume occupied by gas molecules is negligible relative to the total volume of their container.
Geysers are formed when groundwater is heated by nearby magma. Please select the best answer from the choices provided T F
The pressure of a gas sample at 60.0 °C is decreased from 3.40 atm to 2.60 atm by cooling at a constant volume. What is the temperature (in °C) of the gas at 2.60 atm?
When the pressure of a gas is decreased from 3.40 atm to 2.60 atm, the temperature of the gas will decrease from 60.0 degree celsius to 45.88 degree celsius.
What is Gay-Lussac law?Gay -Lussac law states that the pressure and temperature is in direct proportions. Thus, pressure increases with an increase in temperature. The relation can be mathematically expressed as follows:
P/T = a constant. Hence,
P1/T1 = P2/T2
The initial pressure of the sample is given, 3.46 atm and the initial temperature is 60 °C. The final temperature of the gas when gas the expand to the lower pressure of 2.60 atm is calculated as follows:
[tex]T_{2} = \frac{P_{2}T_{1}}{P_{1}}[/tex]
= (60 °C× 2.60 atm) / 3.40 atm
= 45.88 °C.
Hence, the final temperature of the gas which is expanded from the pressure of 3.40 atm to 2.60 atm with an initial temperature of 60 °C is 45.88 °C.
To find more about Gay-Lussac law, refer the link below:
https://brainly.com/question/2683502
#SPJ2
PLEASEE HELPPP
what is the ph of 1.0 times 10^-2 M HBr
Answer:
The pH of a solution with the [H + ] = 1 × 10 -2 M is 2 and the pH of a solution with the [H + ] = 1 × 10 -10 M is 10. ( I think this is correct ).
Explanation:
HELP ANYONE PLEASE ASAP TYY!!!
Which substances are contained in saliva and tears to break down pathogens?
enzymes
acids
oils
sweat
Answer:
A. Enzymes
Explanation:
Enzymes are in our saliva and tears. They help break down pathogens and the cell wall of bacteria.
I hope it helps! Have a great day!
Muffin~
Answer:
A. Enzymes.
Explanation:
Enzymes break down things and they are in both our saliva and tears.
I hope it helps! Have a great day!
.-.
What is Solution Concentration with examples
[tex]\qquad \qquad \huge \pink {\sf{☁Answer☁}} \\ \\ [/tex]
Solution Concentration or the concentration of the solution.The amount of solute dissolved in a particular amount of the solvent is a crucial parameter and is called Solution ConcentrationEXAMPLE →if you add one teaspoon to two cups of water, the concentration could be reported as 1 t salt per 2 c water.[tex]\purple{\rule{15mm}{2.9pt}} \red{\rule18mm{2.5pt}} \orange{ \rule18mm{2.5pt}}[/tex]
[tex]\sf{\:мѕнαcкεя\: ♪...}[/tex]
1. -A mixture of aluminum metal and chlorine gas reacts to form aluminum chloride (AlCl3): 2Al(s) +
3Cl2(g) → 2AlCl3(s). How many moles of aluminum chloride will form when 5 moles of chlorine gas react
with excess aluminum metal?
Answer:
3.33 moles
Explanation:
We know that our limiting reactant is chlorine so we just have to figure out how much of the product aluminum chloride (AlCl3) would be formed from 5 moles of chlorine gas. As we can see in the balanced equation, the mole ratio of chlorine gas (Cl2) to aluminum chloride is 3:2 based on the coefficients of the species. All you have to do from here is divide the amount of moles of chlorine gas by its own coefficient and then multiply the number you receive by the coefficient of AlCl3.
5/3=1.66
1.66*2=3.33
Draw the major product of the given reaction. Include minimized formal charges.
The major product of the given chemical reaction is given as drawn in the attached picture.
What is a Major Product in Chemistry?A major product in chemistry refers to the product whose amount is the greatest after a chemical reaction has taken place.
In order to find the major product, it is required for the Markovnikov Rule to be applied.
This rule states that when hydrogen is mixed with carbon with more hydrogen, then the major product will be gotten.
Learn more about Major Products at:
https://brainly.com/question/17116534
Complete and balance the following equation K+H2O
Explanation:
hello
2K + 2H2O ==》2KOH + H2
giving brainliest please help!
The buffer that is adjusted to control acid-base balance is ________. plasma protein hemoglobin phosphate buffer bicarbonate: carbonic acid buffer
The buffer that is adjusted to control acid-base balance is referred to as a bicarbonate buffer.
What is a Buffer?This consists of a weak acid and its conjugate base, or vice versa and resist changes in the pH of the solution.
The bicarbonate buffer is involved in acid-base homeostasis by removing CO2 and hydrogen ions, respectively, from the body.
Read more about Buffer here https://brainly.com/question/22390063
What is the best reason that fire is not considered a living organism?.
Answer:
all living organisms have cells fire does not
In the case of pathogen infections, chronic inflammation indicates
that the host does not have functional defense mechanisms.
that the host is fighting a lengthy battle against the pathogen.
that the pathogen has become an established part of the host's resident microbiota.
that the pathogen infection has been effectively overcome by the host.
Answer:
The answer is that the pathogen has become an established part of the host's resident microbiota. :)
Have an amazing day!!
Please rate and mark brainliest!!
If a gas has a volume of 1.25 l at a temperature of 300 k, what will the volume change to if the container is cooled to 200k
The volume of the gas when the container is cooled from a temperature of 300 K to 200 K is 0.83 L
Charles' law
Charles' law states as follow:
V₁ / T₁ = V₂ / T₂
Where
V₁ is the initial volume T₁ is the initial temperature V₂ is the new volume T₂ is the new temperature How to determine the new volumeFrom the question given above, the following data were obtained
Initial volume (V₁) = 1.25 LInitial temperature (T₁) = 300 KNew temperature (T₂) = 200 KNew Volume (V₂) =?V₁ / T₁ = V₂ / T₂
1.25 / 300 = V₂ / 200
Cross multiply
300 × V₂ = 1.25 × 200
Divide both side by 300
V₂ = (1.25 × 200) / 300
V₂ = 0.83 L
Learn more about gas laws:
https://brainly.com/question/6844441
