NEED HELP ASAP PLZZZ

Answer:

–2400 N

Explanation:

This is a physics question. However, the answer to the question is given below.

We'll begin by converting 36 Km/hr to m/s. This can be obtained as follow:

3.6 Km/hr = 1 m/s

Therefore,

36 Km/hr = 36 Km/hr × 1 m/s / 3.6 km/hr

36 Km/hr = 10 m/s

Thus, 36 Km/hr is equivalent 10 m/s.

Next, we shall determine the acceleration of the car. This can be obtained as follow:

Initial velocity (u) = 10 m/s

Final velocity (v) = 0 m/s

Time (t) = 5 s

Acceleration (a) =?

a = (v – u) / t

a = (0 – 10) / 5

a = – 10 / 5

a = –2 m/s²

Finally, we shall determine the force required to stop the car. This can be obtained as follow:

Mass (m) = 1200 Kg

Acceleration (a) = –2 m/s²

Force (F) =?

F = ma

F = 1200 × –2

F = –2400 N

NOTE: The negative sign indicate that the force is in opposite direction to the motion of the car.

Answer:

[tex]\boxed {\boxed {\sf 2.73 \ g \ He}}[/tex]

Explanation:

We are asked to find the mass of helium gas given a volume.

1 mole of any gas occupies a volume of 22.4 liters. So, 1 mole of helium gas contains 22.4 liters of helium. Create a ratio using this information.

[tex]\frac {1 \ mol \ He }{ 22.4 \ L \ He}[/tex]

We are converting 15.3 liters of gas to moles, so we multiply by that value.

[tex]15.3 \ L \ He *\frac {1 \ mol \ He }{ 22.4 \ L \ He}[/tex]

The units of liters of helium (L He) cancel.

[tex]15.3 *\frac {1 \ mol \ He }{ 22.4}[/tex]

[tex]\frac {15.3}{22.4} \ mol \ He[/tex]

[tex]0.6830357143 \ mol \ He[/tex]

The molar mass is the mass of 1 mole of a substance. These values are found on the Periodic Table as atomic masses, but the units are grams per moles. Look up the molar mass of helium.

Create another ratio using the molar mass.

[tex]\frac {4.0026 \ g \ He}{1 \ mol \ He}[/tex]

Multiply by the number of moles we calculated.

[tex]0.6830357143 \ mol \ He *\frac {4.0026 \ g \ He}{1 \ mol \ He}[/tex]

The units of moles of helium (mol He) cancel.

[tex]0.6830357143*\frac {4.0026 \ g \ He}{1 }[/tex]

[tex]2.73391875 \ g \ He[/tex]

The original measurement of volume has 3 significant figures, so our answer must have the same.

For the number we calculated, that is the hundredths place.

The 3 in the thousandths place to the right (2.73391875) tells us to leave the 3 in the hundredths place (2.73391875).

[tex]2.73 \ g \ He[/tex]

15.3 liters of helium gas is approximately 2.73 grams of helium.

Answer:

A ball is thrown straight up from a rooftop 320 feet high. The formula below describes the ball's height above the ground, h, in feet, t seconds after it was thrown. The ball misses the rooftop on its way down and eventually strikes the ground. How long will it take for the ball to hit the ground? Use this information to provide tick marks with appropriate numbers along the horizontal axis in the figure shown.

h=-16t^2+16t+320

Explanation:

Answer is that : no heat will flow

Answer:

Heat will flow from the ice cube to the dry ice

Explanation:

Answer:

B

Explanation:

Pure water always has equal concentrations of hydrogen and hydroxide ions.

Answer:

In this reaction, nitrogen acts as the oxidizing agent. Mg is a reducing agent.

Answer:to help understand the stuff more

Explanation:

Answer:

Cl 3 I

Explanation:

Molecular Weight. 233.36. Appearance. Red-orange to brown powder or chunks. Melting Point. 63 °C

Answer:

A, Cardiovascular system

cardiovascular system

Answer:

sodium fusion is changed to sodium sulphide if sulphur is present in the compound

Answer:

Having high melting point.

Explanation:

The original product has high melting point as compared to the mixture product because in the original product, the element is present in its pure state and we know that pure substances have high melting point as compared to mixture substances due to the presence of strong intercellular forces between them which is hard to break so that's why we can say that the original product has high melting point.

Answer:

Zn + O2 = ZnO

Mg + O2 = MgO

Cu + O2 = CuO

Al + O2 = Al2O3

Explanation:

Answer:

D .

Explanation:

Individuals are all equally likely to successfully reproduce, but the genome will mutate to erase harmful traits.

Explanation:

This reaction is also known as double decomposition reaction.

HCl + CaCO3 + MgCO3 → H2O + H2 + CO2 + CaCl2 + MgCl2

Answer:

C. ATP.

Explanation:

During the process of aerobic cellular respiration, energy is said to be released in three main stages: glycolysis, Krebs cycle and oxidative phosphorylation (electron transport chain). The electron transport chain produces the most energy and it involves the transfer of electrons through series of complex proteins.

As the electrons move through the individual complexes, energy is lost to form a proton gradient (H+). The proton gradient powers the synthesis of ATP from ADP as catalyzed by ATP synthase.

Answer:

45 °C.

Explanation:

From the question given above, the following data were obtained:

Heat (Q) = 1125 J

Mass (M) = 250 g

Final temperature (T₂) = 55 °C

Specific heat capacity (C) = 0.45 J/gºC

Initial temperature (T₁) =?

The initial temperature of the iron can be obtained as illustrated below:

Q = MC(T₂ – T₁)

1125 = 250 × 0.45 (55 – T₁)

1125 = 112.5 (55 – T₁)

Divide both side by 112.5

1125/112.5 = 55 – T₁

10 = 55 – T₁

Collect like terms

10 – 55 = –T₁

–45 = –T₁

Multiply through by –1

45 = T₁

T₁ = 45 °C

Therefore, the initial temperature of the iron is 45 °C

Answer:

27.79 g to the nearest hundredth.

Explanation:

2Na + Cl2 ---> 2NaCl

Using the molar masses , the theoretical yield is:

46 g of Na yields  46 + 35.5*2 g NaCl

46 g ---> 117 g NaCl  so

11.5 g ----> 117 * 11.5 / 46 g NaCl

But, as the yield is 90%

the actual yield is 0.95 * 117 * 11.5 / 46

= 27.79 g.

Answer:

s orbital

Explanation:

it has the lowest energy because

Paulis law state that orbitals with lower energy must be fill first before that of higher energy

and the s orbital is filled first

Answer:

[tex]\boxed {\boxed {\sf 8.0 \ M \ NaCl}}[/tex]

Explanation:

Molarity is a measure of concentration in moles per liter, therefore the formula is:

[tex]molarity= \frac{moles \ of \ solute}{lites \ of \ solution}[/tex]

There are 2.0 moles of solute or sodium chloride dissolved in 0.25 liters of water or solution.

Substitute these values into the formula.

[tex]molarity= \frac{ 2.0 \ mol \ NaCl}{0.25 \ L}[/tex]

Divide.

[tex]molarity=8 \ mol \ NaCl / L[/tex]

Molarity is measured in molars or M. 1 molar is equal to 1 mole per liter, so our answer is equal to 8 molars.

[tex]molarity= 8 \ M \ NaCl[/tex]

The original measurements of moles and liters have 2 significant figures, so our answer must have the same. For the number we calculated, that is the tenths place. There are no numbers to round, so we add a 0 in the tenths place.

[tex]molarity= 8.0 \ M \ NaCl[/tex]

The molarity of the solution is 8.0 M NaCl.

1. La tendencia general de la electronegatividad durante un período es que la electronegatividad aumenta durante un período

La opción correcta es a. Incremento

Razón

El número de electrones de valencia aumenta durante un período, por lo

que aumentar la tendencia del átomo a lograr la estructura de octeto

estable requiriendo atraer (cada vez menos a medida que avanzamos por

el período desde la izquierda a la derecha) compartieron electrones

cuando se forman enlaces, lo que  aumenta electronegatividad

2. El orden de electronegatividad creciente es Li → Ca → C → Se

Razón

La electronegatividad aumenta a lo largo del período y disminuye en el grupo.

Las ubicaciones de los elementos dados son;

Primero escribimos los elementos con los números de grupo más altos,

que son Se y C, después de lo cual tenemos Ca, luego Li, por lo tanto, en

orden creciente, obtenemos;

Li → Ca → C → Se

3. La opción correcta es d. N (nitrógeno)

Razón

El potencial de ionización representa la energía necesaria para eliminar un electrón de un átomo.

El potencial de ionización disminuye en un grupo y aumenta a lo largo de un período de izquierda a derecha.

Tenemos;

Por lo tanto, el elemento con mayor potencial de ionización es aquel que se encuentra en la posición más alta en el grupo 15 entre los elementos dados, que es el nitrógeno, N

4. La opción correcta para la definición de electronegatividad es la opción (a);

un. Es la tendencia relativa de un elemento a atraer electrones hacia sí mismo.

Razón

La electronegatividad es la capacidad relativa de un elemento dado para atraer electrones compartidos hacia sí mismo.

Por lo tanto, la opción correcta es a. es la tendencia relativa de un elemento a atraer electrones hacia sí mismo

Obtenga más información sobre la electronegatividad y la energía de ionización aquí;

https://brainly.com/question/13961537

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

[tex]\boxed{\pmb{\color{gold}{\sf{2SO_{2}(g) + O_{2}(g)\dashrightarrow 2SO_{3}(g)}}}}[/tex]

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

[tex]\boxed{\sf {2SO_2\atop Sulphur\:DiOxide}+{O_2\atop Oxygen}\longrightarrow {2SO_3\atop Sulphur\:trioxide}}[/tex]

Hence balanced.

Answer:

các oxit đồng khi nó tiếp xúc với không khí. nó phản ứng đặc biệt với oxy trong không khí (không phải hơi ẩm), và tạo ra nấm mốc

Answer:

c

Explanation:

Cạnh của hình lập phương là

³\(125 = 5cm

Diện tích đáy của hình lập phương là

5²=25cm²

Đáp án C

Answer:

Requires two Mg²⁺ cofactors and as such demonstrates metal-ion catalysis

Explanation:

Electrostatic catalysis or metal ion catalysis is a catalytic mechanism that makes use of metalloenzymes, such as enolase along with a metal ion which is bound tightly, including, Mo⁶⁺, Ni³⁺, Co³⁺, Mn²⁺, Zn²⁺, Cu²⁺, and Fe²⁺, to undertake a catalysis

For maximal activity, enolase requires the presence of 2 equivalent metal ions in each site which is active

Therefore, the correct option is; requires two Mg²⁺ cofactors and as such demonstrates metal-ion catalysis