please help quick
How much work is done by the people in raising the load 3 meters if the combined pulling force of the men on the rope is 700 newtons?
A.233 N·m
B. 703 N·m
C. 2,100 N·m
D. 400 N·m

Answer:

a seat

Explanation:

The phrase “seat value” is used in the hospitality and bar sectors to describe how much money each seat or square foot of customer area must generate to justify its existence.

An area to sit is a seat. The phrase may also refer to headquarters in a more general meaning as well as extra elements such a back, armrest, and head restraint.

Being in the centre allows you to benefit from both the advantages of both front and back seating while balancing out their extremes. While you're still close enough to be paying careful attention to the lecture, the middle rows will relieve you of the pressure and expectations of the front.

By remaining seated, students help avoid physical altercations. There is more time spent on task when pupils are seated.

Environmental psychology, which gives people the impression that they have some degree of influence over their daily lives, is the driving force behind all of this behavior.

Therefore, seat used by people.

Learn more about seat here:

https://brainly.com/question/19261993

#SPJ2

Suns' gravitational pull​ prevents the planets in our solar system from floating away, therefore the correct answer is option D.

It is a structure in which the sun's attractive force causes all the planetary systems and celestial bodies to revolve around this.

The Sun is believed to be located in the system's center in the sun-centered concept upon which our Solar System is founded.

The primary factor that causes the planets in the solar system to revolve around the sun is gravity.

The sun's pull of gravity prohibits the planets in our planetary system from moving away, hence option D is the appropriate

To learn more about Solar systems, refer to the link given below;

brainly.com/question/12075871

#SPJ2

Answer:

answer to this question is c

Answer:

3

Explanation:

because the battery's power is not functioning well

Hi there!

To find how much the spring stretches with the mass attached, we must find the spring's equilibrium point.

The equilibrium point satisfies the following:

[tex]\large\boxed{\Sigma F = 0}[/tex]

The two forces acting in this situation are the weight of the mass and the spring force.

The spring force (restoring force) is in the opposite direction of the weight, so:

[tex]\Sigma F = 0 = Mg- k\Delta x[/tex]

Mg = weight

k = Spring Constant (N/m)

Δx = distance to equilibrium point (m)

Now, we can set the two equal to each other:

[tex]Mg = k\Delta x\\\\544 = 1146\Delta x\\\\\boxed{\Delta x= .475 m}[/tex]

Answer:

it changed because the rock put the pressure all in one spot.

Explanation:

Answer:

56 proton sir

have a nice day

Answer:

a. 2.5 m/s

Explanation:

50 / 20 = 2.5 m/s

Answer:

it will float up cause its has gravity

When Jacob cuts some holes in the disk and immerses it again in a vessel of water it will now float at the top. Thus, the correct option for this question is A.

An object floats when the weight force on the object is balanced by the upward push of the water on the object. The upwards push of the water increases with the volume of the object that is underwater. It is not affected by the depth of the water or the amount of water.

According to the context of this question, when a disk does not have holes in it, it will definitely sink to the bottom of the water because it has high density, but when the hole is made in the disk, the water is passed out from them and now, the upward force is minimized that cause less density as compared to previous.

Therefore, when Jacob cuts some holes in the disk and immerses it again in a vessel of water it will now float at the top. Thus, the correct option for this question is A.

To learn more about Upward force, refer to the link:

https://brainly.com/question/24279743

#SPJ2

Answer:

D, A

Explanation:

#1

Height is same for all cars

So they all will arrive at same speed but A will come first

Option D

Answer:

Observation is essential in science. Scientists use observation to collect and record data, which enables them to construct and then test hypotheses and theories. Scientists observe in many ways – with their own senses or with tools such as microscopes, scanners or transmitters to extend their vision or hearing. These tools allow for more precise and accurate observations. Scientists also use equipment to measure things like radiation or pH – phenomena not directly observable.

Explanation:

Answer: 250n

Explanation:

The formula for gravitational force is: F = (gMm)/r^2

There are two factors at play here:

1) The mass of the planet 'M'

2) The radius 'r'

We can ignore the small M and the g, they are constants that do not alter the outcome of this question.

You can see that both M and r are double that of earth. So lets say earth has M=1 and r=1. Then, new planet would have M=2 and r=2. Let's sub these two sets into the equation:

Earth. F =  M/r^2 = 1/1

New planet. F = M/r^2 = 2/4 = 1/2

So you can see that the force on the new planet is half of that felt on Earth.

The question tells us that the force on earth is 500n for this person, so then on the new planet it would be half! So, 250n!

Answer:

Mechanical energy is the ordered movement of the molecules as a single unit. Thermal energy is the random movement of the molecules. Mechanical energy can be 100% converted to thermal energy, but thermal energy cannot be fully converted to mechanical energy.

=============================================

Explanation:

To compute the speed, we divide the distance traveled over the time duration.

For instance, if a car goes 100 km in 5 hours, then its speed is 100/5 = 20 km per hour.

-----------------

For section A, the car travels 30 km over the course of 2 hours (since 11:00-9:00 = 2:00)

speed = distance/time = (30 km)/(2 hrs) = 15 km/hr

-----------------

We don't need to do any computations for section B. It's a flat horizontal line, so the speed is zero. There's no change in distance, so the car is stationary for this 1 hour period.

You could say speed = distance/time = 0/1 = 0 km/hr if you wanted.

-----------------

For section C, its change in distance is 60-30 = 30 km and the change in time is 0.5 hour (because it spans from 12:00 to 12:30)

So, speed = distance/time = (30 km)/(0.5 hr) = 60 km/hr

The steeper slope of section C, compared to section A, means the car is going faster.

-----------------

Section D spans from 12:30 to 14:00. This is a time period of 14:00-12:30 = 1:30 = 1.5 hours. The change in distance is 60 km

(60 km)/(1.5 hrs) = 40 km/hr

The speed of the car during section D is 40 km per hour.

Side note: if you were talking about velocities instead of speeds, then section D would have a negative velocity of -40 km/hr to indicate the car is going the opposite direction (compared to sections A and C). However, speed is always nonnegative.

Answer:

d. action force and the reaction force act on two different objects.

Hope you could understand.

If you have any query, feel free to ask.

In an action-reaction pair, action force and the reaction force act on two different objects.

Newton's Third Law of Motion states that "For every action, there is an equal and opposite reaction, action and reaction act on two different bodies."

It means that equal force are act on reaction force that is it is also known as reciprocal law of motion.

When considering the options,

So, In an action-reaction pair, action force and the reaction force act on two different objects. Thus, Option B is the correct answer.

Learn more about Newton's third law,

https://brainly.com/question/974124

#SPJ2

Answer:

x= 100 m

Explanation:

m= 600 kg

t= 10 s

F= 1200N

v0= 0

-----

F=ma

a=F/m

x= (v0)t + (1/2)(a)(t^2)

x= (1/2)(F/m)(t^2)

x= (1/2)(1200/600)(10^2)

x= 100m

Answer:

36,000 J

Explanation:

Work is equal to Force times Distance:

W = Fd

W = 60N*600m

36,000 = 60N*600m

Answer:

it's zero

Explanation:

it is there is your answer

Answer:

Normative

Explanation:

It is normal occurance but not unnatural

Answer: frosted glass

Explanation:

Answer:

C

Explanation:

Frosted Glass

Explanation:

The planets never travel in a straight line as they orbit the Sun. According to Newton's second law of motion, this must mean that: Your Answer: The planets have angular momentum.'

HOPE THAT HELPS YOU.

MARK ME BRINILYLIST

HAPPY HOLIDAYS

According to Newton's second law of motion, this must mean that force is acting on the planets. The correct option is (b).

As per Newton's second law of motion, an object's acceleration is inversely related to its mass and directly proportional to the net force exerted on it.

The curving courses of the planets in their solar system show that they are constantly changing their direction, as it causes them to accelerate.

The planets are being accelerated in the direction of the Sun as a result of the Sun's gravitational pull on them. The planets continually speed up toward the Sun due to the centripetal force required to maintain them in their orbits, which is caused by the gravitational attraction between the Sun and the planets. As a result, the planets orbit the Sun in elliptical patterns rather than in a straight line.

Hence, According to Newton's second law of motion, this must mean that force is acting on the planets. The correct option is (b).

To learn more about Force, here:

https://brainly.com/question/13191643

#SPJ3

The complete question is:
The planets never travel in a straight line as they orbit the Sun. According to Newton's second law of motion, this must mean that _________.

(a) the planets are always accelerating

(b) a force is acting on the planets

(c)  the planets have angular momentum

(d) the planets will eventually fall into the Sun

Answer:

0.76 lbs (if shoes 2lbs)

Explanation:

Gravity on Mars is only ~38% as strong as it is on Earth, so objects would only weigh ~38% of their Earth weight.

Answer:

Ωmass

Explanation:

If there were no dark energy in the universe, the value of Ωmass would determine the evolution and fate of the universe.

Answer:

The capacitance C of a capacitor is defined as the ratio of the maximum charge Q that can be stored in a capacitor to the applied voltage V across its plates. In other words, capacitance is the largest amount of charge per volt that can be stored on the device: C = Q V . 1 F = 1 C 1 V .

Explanation:

A capacitor's capacity to hold an electric charge when a potential difference (voltage) is applied across its plates is measured by the capacitance of the device.

It can be calculated using the formula C = Q/V,

where Q is the electric charge stored on the capacitor in coulombs (C), C is the capacitance in farads (F), and V is the voltage across the capacitor in volts (V). The capacitor's physical properties, such as the area of the plates, the space between them (dielectric separation), and the substance between the plates (dielectric constant), all affect capacitance. A better charge storage capability is indicated by a higher capacitance value.

To know more about capacitance, here

brainly.com/question/31871398

#SPJ2

Answer:

A

Explanation:

Current effiency

= 75/147

= 0.5102

New Efficiency

= 120/100 × 0.5102

= 0.6122

Only option A satisfies this efficiency.

Answer:

50 Joules

Explanation:

Answer:

This will require 266.9 of heat energy.

Explanation:

To calculate the energy required to raise the temperature of any given substance, here's what you require:The mass of the material, m The temperature change that occurs,  ΔT The specific heat capacity of the material,

c

(which you can look up). This is the amount of heat required to raise 1 gram of that substance by 1°C.

Here is a source of values of

c for different substances:

Once you have all that, this is the equation:

Q=m×c×ΔT(Q is usually used to symbolize that heat required in a case like this.)For water, the value of c is 4.186g°C So, Q=750×4.186×85=266=858=266.858