using the balanced equation below how many grams of lead(||) sulfate would be produced from the complete reaction of 23.6 g lead (|V) oxide

Answer:

A- Butyric acid and methylammonium chloride.

Explanation:

The mass of CO₂ gas produced during the combustion of one gallon of octane is 8.21 kg.

The given parameters:

The mass of the octane burnt is calculated as follows;

[tex]m = \rho V\\\\m = 0.703 \ \frac{g}{ml} \times 3.79 \ L \ \frac{1000 \ ml}{L} \\\\m = 2,664.37 \ g[/tex]

The combustion reaction of octane is given as;

[tex]2C_8H_{18} + \ 25O_2 \ --> \ 16CO_2 \ + \ 18H_2O[/tex]

From the reaction above:

228.46 g of octane -------------------> 704 g of  CO₂ gas

2,664.37 of octane --------------------> ? of CO₂ gas

[tex]= \frac{2,664.37 \times 704}{228.46} \\\\= 8,210.3 \ g\\\\= 8.21 \ kg[/tex]

Thus, the mass of CO₂ gas produced during the combustion of one gallon of octane is 8.21 kg.

Learn more about combustion of organic compounds here: https://brainly.com/question/13272422

Answer: In atoms, there are a total of four quantum numbers: the principal quantum number (n), the orbital angular momentum quantum number (l), the magnetic quantum number (ml), and the electron spin quantum number (ms).

Answer:

(n)

(i)

(mı)

(ms) s is suppose to be smaller than the m

Explanation:

the principal quantum number (n)

the orbital angular momentum quantum number (I)

the magnetic quantum number (ml)

the electronic spin quantum number (ms)

Answer:

1. More data should be collected to get a more reliable average

2. A boiling point at 1.5 atmospheres could be predicted fairly well

3. The actual boiling point is probably between 34 C and 40 C

4. By taking 10 measurements of each of the five liquids and finding an average

5. The thermometer being used might need to be recalibrated

Explanation:

Took the quick check

The substances created during chemical reactions, on the other hand, do not simply revert to their initial state. The most essential thing to remember is that the makeup of a material does not change when it undergoes a physical change, but it does change when it undergoes a chemical change.

Answer:

the most important thing for you to remember is that in a physical change composition of a substance does not change and in a chemical change the composition of a substance does change

Answer:: We're asked to find the molar concentration of the NaCl solution given some titration data.

Explanation:

Answer:

0.10 M NaHA

Explanation:

Answer:

Milk is essentially a colloidal dispersion of fat in water. ... However, the fact remains that the fat and water components cannot be mixed together from a solution. There are therefore, two distinct immiscible liquid phase's present, which is why it is a heterogeneous mixture.

Answer:

B

Explanation:

We can see here that the functional group that the molecule have is: B. Carbonyl

A functional group is a specific group of atoms or bonds within a molecule that is responsible for the characteristic chemical reactions and properties of that molecule. Functional groups are the parts of organic molecules that determine their reactivity and the types of chemical reactions they can undergo.

In organic chemistry, functional groups play a crucial role in understanding the structure and behavior of molecules. Different functional groups confer distinct properties to molecules, influencing their physical properties, solubility, acidity or basicity, and interactions with other molecules.

Learn more about functional group on https://brainly.com/question/10058230

#SPJ2

Answer:

8,346 kmxm/s2

Explanation:

this is physics not chem but you just multiply 13 by 642 to get 8,346. also I'm sorry but it's easy

The example which accurately describes a solution is; Polar sugar molecules dissolve in water, which is polar.

According to the question:

The formation of a solution requires that the solvent and solute be of the same polarity.

In essence, the example which accurately describes a solution is; Polar sugar molecules dissolve in water, which is polar.

Read more on solutions and polarity:

https://brainly.com/question/9485955

Answer:

Polar sugar molecules dissolve in water, which is polar.

Explanation:

I did the Exam and got it right!

Answer:

1. How many moles of oxygen will occupy a volume of 2.5 liters at 1.2 atm and 25° C? PV = V (1.2 n. 0821) (298) = 123 mols 2.

2.0 moles of oxygen gas will occupy a volume of 6.67 L at the same temperature and pressure.

Moles is a unit of measurement used in chemistry to express the amount of a substance. It is a counting unit that represents the number of particles, such as atoms, molecules, or ions, in a given sample.

One mole of a substance is defined as the amount of that substance that contains Avogadro's number of particles, which is approximately 6.022 x 10²³. This number is based on the concept that atoms, molecules, and ions are extremely small and difficult to count individually, so using moles allows for a more practical and convenient representation of quantities.

Given:

Moles of oxygen gas (initial) = 0.45 mol

Volume of oxygen gas (initial) = 1.5 L

Moles of oxygen gas (final) = 2.0 mol

Volume of oxygen gas (final) = ?

Using the principle of molar volume, we can set up the following ratio:

(0.45 mol / 1.5 L) = (2.0 mol / V)

V = (1.5 L × 2.0 mol) / 0.45 mol

V = 6.67 L

Learn more about Moles, here:

https://brainly.com/question/26416088

#SPJ6

Answer:

is easy to poiling

Explanation:

also is dificult to melting

The balanced dissociation equation for Cs₂CO₃ is:

Cs₂CO₃(aq) —> Cs⁺(aq) + CO₃²¯(aq)

A dissociation equation is an equation showing the available ions present in a solution.

To obtain the dissociation equation, the compound must be dissolved in water to produce an aqueous solution.

The dissociation equation for Cs₂CO₃ can be written as follow

Cs₂CO₃(aq) —> Cs⁺(aq) + CO₃²¯(aq)

Learn more about dissociation equation: https://brainly.com/question/1903354

Answer:

tiny crystals of the mineral quartz, which is made out of silica and oxygen

Well, much of the world's sand is made out of the same stuff, tiny crystals of the mineral quartz, which is made out of silica and oxygen, the two most common elements in Earth's crust.

Answer:

25%

Explanation:

Ammonium Chloride NH4CI Fertilizer-grade NH4Cl usually contains 25% N. About two-thirds of the world capacity for manufacture of this material is located in Japan, with the remaining one-third situated in India and China.

Answer:

C2Br6

because bromine is a liquid volatile

According to the forces of attraction and boiling point C₂Br₆ is most volatile as its boiling point is very low.

Forces of attraction  is a force by which atoms in a molecule  combine. it is basically an attractive force in nature.  It can act between an ion  and an atom as well.It varies for different  states  of matter that is solids, liquids and gases.

The forces of attraction are maximum in solids as  the molecules present in solid are tightly held while it is minimum in gases  as the molecules are far apart . The forces of attraction in liquids is intermediate of solids and gases.

The physical properties such as melting point, boiling point, density  are all dependent on forces of attraction which exists in the substances.

Learn more about forces of attraction,here:

https://brainly.com/question/14365107

#SPJ2

Answer:

The speed of light, c, equals the wavelength, λ (pronounced lambda), times the frequency, ν, (pronounced noo).

c=λν

c is a constant. It is usually given as 3.00×108 m/s or 3.00×1010 cm/s rounded to three significant figures.❤

Answer:

1 s-orbital, 3 p-orbital and 5 d-orbital

Answer:

there are a total of nine orbitals in a third energy level

Explanation:

Answer:

3 significant figure

Explanation:

Trailing zeros in a number are significant ONLY is the number contains a decimal point.

So if it was 100cm with out the decimal point would only have 1 significant figure.

nothing will happen

if you calculate the water potiential for both solutions

you get 2(0.1)(R)(T) and 1(0.2)(R)(T)

which is the same thing, so its isotonic.

Answer:

Periodicity is caused by regular and predictable variations in element atomic structure. ... The rows in the periodic table (the periods) reflect the filling of electrons shells around the nucleus, so when a new row begins, the elements stack on top of each other with similar please help me rank up

Periodicity means the repeating trends in properties of elements in a regular interval.  Precocity in chemical properties depends on the atomic structure because, the size, number of electrons, etc affects their reactivity.

Periodicity is the repetition in in trends in properties after a regular interval. In periodic table, all the elements are classified into different groups and periods.

Groups are vertical columns containing elements of same number of valence electrons and similar chemical and physical properties. Periods are horizontal rows where elements are arranges in the increasing order of atomic number.

Along a period the atomic size decreases, ionization energy and electronegativity increases. But down a group just the reverse for this happens.

In a chemical reaction only valence electrons are participating and the size and number of valence electrons etc affects the chemical reactivity of elements. That's why it is said like periodicity in chemical properties is based on the atomic structure.

To find more on periodicity, refer here:

https://brainly.com/question/16061498

#SPJ2

Answer:

f the vapor pressure of water at 20.0 o C is 17.535 torr, and the atmospheric pressure measured by a barometer was 757.3 torr, what is the partial pressure of H2 in the gas mixture

Partial pressure of H2 in gas mixture is :

739.765 torr .

Total  pressure of mixture =

Partial of hydrogen + Partial pressure of oxygen

Partial of Hydrogen = Total pressure - partial   pressure  of  oxygen

Here total pressure = 757.3 torr

Partial pressure of oxygen = 17 . 535 torr

Total pressure = 757 . 3 - 17 . 533

                        = 739.765 torr.

To learn more about total pressure refer to :

https://brainly.com/question/22264785

#SPJ2

The molarity of the NaOH solution required for the reaction is 0.186 M

We'll begin by writing the balanced equation for the reaction

H₂C₂O₄ +2NaOH —> Na₂C₂O₄ + 2H₂O

From the balanced equation above,

The mole ratio of the acid, H₂C₂O₄ (nA) = 1

The mole ratio of the base, NaOH (nB) = 2

From the question given above, the following data were obtained:

Volume of the acid, H₂C₂O₄ (Va) = 22.14 mL

Molarity of the acid, H₂C₂O₄ (Ma) = 0.105 M

Volume of the base, NaOH (Vb) = 25 mL

MaVa / MbVb = nA/nB

(0.105 × 22.14) / (Mb × 25) = 1/2

2.3247 / (Mb × 25) = 1/2

Cross multiply

Mb × 25 = 2.3247 × 2

Mb × 25 = 4.6494

Divide both side by 25

Mb = 4.6494 / 25

Therefore, the molarity of the base, NaOH solution is 0.186 M

Learn more: https://brainly.com/question/25739717

Answer:

The correct answer is 6.265 M.

Explanation:

To find the molarity of the solution, we first must recall that molarity represents the number of moles of solute divided by the number of liters of solution. Thus, our first step should be to convert the solute amount in grams to moles, using the given molar mass.

266.07 g * (1 mol/169.88 g) = 1.5662 mol

Now, we can find the molarity using the following formula:

Molarity = moles solute/liters solution

M = 1.5662 mol/0.25 L

M = 6.265 M

Therefore, the molarity of the solution is 6.265 M.

Hope this helps!

Answer:

Cis-2-pentene or Z-2-pentene

We can call a person by the word gentleman and Sir or from his/her real name.

If there is a name/surname you can't make out due to a speaker's manner of speech then I will call him gentleman or Sir or I will ask him his real name. Gentleman is a word that is used for noble person and Sir word is also used in order to give someone respect.

Call a person with his real name is also comes under the manner of speech so we can conclude that we can call a person by the word gentleman and Sir or from his/her real name.

Learn more about manner of speech here:

Learn more: https://brainly.com/question/26023566

Answer: The growth of the plant decides on the presence of plant hormone, auxin which develops in the roots and shoots. Auxins change the rate of elongation in plant cells, controlling how long they become. So, if the tips are removed, there is no auxin made and growth of the plant stops.