Bill sets up an experiment to determine and predict the velocity of a marble at the end of a track. He uses an electronic balance to weigh the marble. He then places the marble at the top of the track and releases it. Artie uses the time it takes the marble to pass through a photogate at the bottom of the track to calculate the velocity of the marble. ill notes that his prediction is significantly higher than his calculated velocity. Which error explains this difference? A) Bill forgot to account for friction. B) Bill forgot to zero the balance and found a weight for the marble that was too low. C) Bill weighed the marble in a weighing dish and failed to account for the mass of the weighing dish. D) Bill didn't position the photogate correctly and got the time required for the top of the marble to pass through, rather than reach the middle.

Answer:

Pop your popcorn for 2 minutes in the microwave but if you like to pop your popcorn old fashion get popcorn seeds and put them in an pot and then put a lid over it then pop it.

Explanation:

Answer:

[tex]1.51 \times 1024 \: \: molecules[/tex]

Explanation:

There are 1.51 x 1024 molecules of carbon dioxide in 2.50 moles of carbon dioxide.

Molecular substances tend to be gases because the intermolecular forces of attraction are comparatively weak. You don't have to break any covalent bonds in order to melt or boil a molecular substance.

The longest intermolecular separation and hence the strongest intermolecular pressure of attraction can be found in the gaseous state of matter.

Although solids' intermolecular interactions were sufficient to maintain themselves in locked places, gases often have weak intermolecular forces that cause them to remain considerably separated. The gases possess greater intermolecular space than solids as a result of these weak forces.

To know more about molecular forces:

https://brainly.com/question/21826959

#SPJ1

Answer:

Covalent bonds usually occur between nonmetals. For example, in water (H2O) each hydrogen (H) and oxygen (O) share a pair of electrons to make a molecule of two hydrogen atoms single bonded to a single oxygen atom. In general, ionic bonds occur between elements that are far apart on the periodic table.

600 kg·m/s

Mass = 200 kg

Velocity = 3 m/s

Power = Mass * Velocity = 200 kg * 3 m/s = 600 kg·m/s

Answer:

Personally, I use Superglue

Explanation:

Answer:

D — All of them

Explanation:

The activation energy in a reaction is the minimum amount of energy required for a chemical reaction to take place. Since all the options are processes in a chemical reaction, D should be the answer.

Answer:

try this

Explanation:

I searched it but I don't know

Answer:

1. Na2SO4(aq)+C4H6BaO4(aq) --> BaSO4(s) + 2C2H3NaO2(aq)

2. 2Na^+1(aq) + SO4^-2(aq) + 4C^+4(aq) + 6H^+1(aq) + Ba^-2(aq) + 4O^-2(aq) --> BaSO4(s) + 2C^-4(aq) + 2H^+1(aq) + 3Na^+1(aq) + 2O^-2(aq)

3. Ba^+2(aq) + SO4^-2(aq) --> BaSO4(s)

Explanation:

Answer:  no

Explanation:

Atoms are not and have never been alive so they can't be considered dead. they simply do not meet any reasonable of life, primarily because they are not complex.

Answer:

9.17 g

Explanation:

1) Calculate mols of PCl5

PCl5 (aq) + 4H2O (l) ⟶ H3PO4 (aq) + 5HCl (aq)

Mass of PCl5: 26.5g

Molar Mass of PCl5 208.24g/mol

Mol of PCl5 = Mass PCl5 /Molar mass PCl5  = 26.5g / (208.24g/mol) = 0.127257011 mol

2) Calculate mols of water needed to react

Mols of H2O per 1 Mols of PCl5 = 4 (because 4 water is needed to Phosphorus pentachloride).

Mols of H2O = Mol of PCl5 * 4 = 0.127257011 * 4 = 0.509028044 mols

3) Calculate Grams of water needed to react

Mols of H2O = 0.509028044 mols

Molar Mass of H2O = 18.015 g/mol

Mass of H2O = Mols of H2O * Molar Mass of H2O

= 0.509028044 mols* 18.015 g/mol = 9.17014021 g

sf = 3

9.17 g

Answer:

1. melting

2boiling

3. freezing

4. condesation

Explanation:

Answer: The statement that correctly describes a physical change is may involve a change in phase but does not involve a change in the molecular structure. The answer is letter B.

Explanation: trust me

Explanation:

OA- because there is breakdown of chemical bonds

Answer:

okkkkkkkkkkkkkkkkkkkkkkkkkkk

We can describe a positive energetic process as any process which increases the internal energy of the system.

A positive energetic reaction or process is often referred to as being Endothermic. This means that the system which is performing the process absorbs energy. Some examples include:

etc

Therefore, we can confirm that a positive energetic process is one in which the system in question absorbs energy, thus increasing its internal energy.

Since I could not locate the options online, I have provided a general explanation of the concept coupled with a few examples.

To learn more visit:

https://brainly.com/question/4345448?referrer=searchResults

Answer:

The total pressure of a mixture of gases can be defined as the sum of the pressures of each individual gas: Ptotal=P1+P2+… +Pn. + P n . The partial pressure of an individual gas is equal to the total pressure multiplied by the mole fraction of that gas.

Explanation:

hope this helps have a wonderfull day!

Answer:

A. Draw a conclusion

Explanation:

correct me if I'm wrong :>

Total mass of carbon must be decreasing in different step of carbon cycle because matter is conserved in the processes and reactions of carbon cycle. Carbon is a matter and it is the major constituent of living organisms.

Carbon cycle refers to processes where carbon move from the atmosphere to the biosphere and Earth and then back to the atmosphere.

It involves processes of using and reusing carbon again and again and it's conservation.

Carbon is an organic matter found in living organisms and total mass of carbon reduces because it is a matter that is conserved.

Carbon is released from that atmosphere, use for photosynthesis, plants and animals consume the plants. They defecate , respirate and carbondioxide is released during respiration.

Therefore,Total mass of carbon must be decreasing in different step of carbon cycle because because matter is conserved in the processes and reactions of carbon cycle. Carbon is a matter and it is the major constituent of living organisms.

Learn more about Carbon cycle from the link below.

https://brainly.com/question/20830841

cyanoacrylate

When cyanoacrylate polymerizes, the cyanoacrylate sticks together on an atomic level, and it becomes solid. Super Glue solidifies in all the microscopic crevices of an object that it moved into when it was a liquid, and it can form chemical bonds with any anions in the object.

The binary salt among the given salts is CaCl₂. The correct option is d,CaCl₂

From the question,

We are to identify the binary salt among the given salts.

First, we will define the term binary salt

A binary salt is a chemical compound that is formed from the mixture of a metal and a non-metal.

Among the given options, CaCl₂ is the salt formed from the mixture of a metal and a non-metal.

The metal is Calcium (Ca)

and the non-metal is Chlorine (Cl)

Hence, the binary salt among the given salts is CaCl₂. The correct option is d,CaCl₂

Learn more here: https://brainly.com/question/3103303

Answer:

Meteorology

Explanation:

Meteorology focuses on Earth's atmosphere and, especially, how changes in the atmosphere affect weather and climate on Earth's surface.

The percentage by mass of the acetic acid is 0.057%.

The given parameters:

The concentration of the acetic acid is calculated as follows;

[tex]C_1V_1 = C_2 V_2\\\\C_1 = \frac{ C_2 V_2}{V_1} \\\\C_1 = \frac{0.01 \times 250}{10} \\\\C_1 = 0.25 \ M[/tex]

The number of moles of acetic acid in the given concentration;

[tex]C = \frac{mol}{L} \\\\mole = CL\\\\mole = 0.25 \times 10 \times 10^{-3} \\\\mole = 0.0025[/tex]

The molar mass of acetic acid = 60 g/mol

The mass of acetic acid in the given number of moles is calculated as follows;

m = conc. x molar mass

m = 0.0025 x 60

m = 0.15 g

The mass of vinegar in the volume and density;

m = density x volume

m = 1.05 x 250

m = 262.5 g

The percentage by mass of the acetic acid is calculated as follows;

[tex]= \frac{0.15}{262.5} \times 100\%\\\\= 0.057 \%[/tex]

Thus, the percentage by mass of the acetic acid is 0.057%.

Learn more about percentage by mass here: https://brainly.com/question/22060503

Answer:

self-pollination.

Explanation:

When the pollen of the flower is transferred to the stigma of the same flower, it is called self-pollination. Cross-pollination occurs when pollen is transferred from one flower to another flower on the same plant, or another plant.

Answer:

It’s in the photo, sorry if it’s really messy!

Explanation:

Please ask if you have any questions!

Answer:

Atmosphere

Explanation:

Natural gas is mainly hydrocarbons like C3H8 and that has hydrogens, water is H2O and had hydrogens, mines have it in the minerals.

Answer:

Substance C

Explanation:

Substance C would be the answer because Substance C has a lower attraction level. Because of this, it takes more energy to take out of in order to become a liquid.

There are 0.566 moles of carbonate in sodium carbonate.

Learn more about number of moles at: https://brainly.com/question/1542846